• Model: S3_KV2
• Shipping Weight: 1lbs
• Units in Stock: 0
• Manufactured by: Sector3
• Recommended configuration:

1. Props:
2. ESC:
3. Motors:
4. Flight controller:

Details:
When we began revising the Komodo V1 we took into consideration the feedback we recieved from our team pilots as well as our customers and made the Komodo V2 the best we could. Below is a list of changes:
* Adjustable GoPro mount (Optional)
* Mobius mount (Optional)
* Fully adjustable tilt on the motor
* Protected FPV camera
* Protected battery area
* Protected electronics area
* Removable electronics tray for easy building and maintenance
* Removable FPV Camera tray
* GoPro mountability..In the J spot and is adjustable from straight up to 45 degrees tilt
* Two different fpv camera mounting locations. The standard location as we had before and a new one to allow up to 45 degrees tilt
* Larger rx tray in the rear that will hold the vtx and the rx.
* Chassis side reshape in the rear to allow more rear tilt with 6" props
* To help accommodate the more aggressive fpv camera angle the mowhawk tip has been moved and the inner boom plate redesigned for maximum clearance
* New, thicker motor plates with a more universal mounting pattern to fit virtually any 250 applicable motor
* New configuration and thicker fpv camera plate
* No more mowhawk shims
* Lighter spacers
* More room under mowhawk for fc and associated wiring
* Relocation holes for fc to be placed forward, back, center, etc. when using the 4n1
* New boom clamps that are thicker for more clamping surface area and use standard 3mm hardware
* New carbon with much better finish edges
* Manual available for download, so no guess work during building
Plus much more..
At sector3 we pride ourselves on our customer service. If you have a comment, concern or question you can reach us anytime via info@sec3research.com or you can post up in our Komodo thread on RC Groups Komodo RC Groups Thread Link