Loading... Please wait...

Our Newsletter

NEW APM2.5.2 APM2.6 Pixhawk Power Module V1.0 Output BEC 3A XT60 Plug

  • Image 1
  • Image 2
  • Image 3
  • Image 4
0.20 LBS
Calculated at checkout

Product Description

This new Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable. The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery.Special for APM2.5.2 APM2.6 Pixhawk flight controller

Note: The Power Module is only designed to power APM/Arduflyer, a RC receiver and accessories (GPS, Radio telemetry). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.

- XT60 Plug
- Max input voltage: 30V
- Max current sensing: 90A
- Voltage and current measurement configured for 5V ADC
- Switching regulator outputs 5.3V and 3A max
- 6P molex cable plugs directly to APM/Arduflyer 2.5's 'PM' connector

- Dimension(mm): 25 x 21 x 9
- Weight(g): 17(include all wire)

Find Similar Products by Category

Write your own product review

Product Reviews

  1. Accurate voltage and current available on Taranis 5 Star Review

    Posted by on 9th Mar 2018

    Just plug in and it is ready to work. There is a setup required to ensure it's accuracy, but not complicated.

Add to Wish List

Click the button below to add the NEW APM2.5.2 APM2.6 Pixhawk Power Module V1.0 Output BEC 3A XT60 Plug to your wish list.

You Recently Viewed...